Local roofersFree to callNo forms to fill out
Serving Parsippany and nearby towns
Menu
Call (862) 693-4349
Flat Roofing

Rubber Roof Repair Parsippany, NJ

A Parsippany roofer who works on EPDM can fix peeling seams, punctures, blisters and membrane shrinkage at walls and curbs, so the roof stays watertight for more seasons. One call to (862) 693-4349 reaches a nearby rubber roof repair pro.

Most EPDM leaks come from a short list of problems. Seams lead the list, since older EPDM roofs were often seamed with liquid adhesive that breaks down over time. Punctures and failed flashing at walls, curbs and vents round out the usual causes.

Shrinkage is a problem specific to rubber roofs. Shrinking rubber pulls tight at the perimeter, tenting across corners and tearing at flashing seams. The fix is releasing the tension and adding new flashing, not just caulking the gap.

Avoid one common shortcut before the roofer arrives. Asphalt roof cement, tar and many general purpose sealants contain solvents that soften and swell EPDM, and nothing made for rubber will bond over them later. In the meantime, catch drips in a bucket and keep off a wet, slippery roof.

Many rubber roof repair calls in Parsippany also turn up a need for rubber roof installation or flat roof repair.

Dealing with this in Parsippany, NJ right now? Call (862) 693-4349 and describe the problem to a roofer who works in Parsippany.

Call now
The process

The rubber roof repair process

EPDM repairs depend on surface preparation more than anything else.

  1. Find the leak

    The inspection traces the leak from the stain back to seams, flashing and penetrations. The roofer also checks whether water has soaked the insulation underneath.

  2. Prepare the surface

    Weathered EPDM is scrubbed with a membrane cleaner to remove dirt, chalking and oxidation. Any old tar or asphalt patch is removed first.

  3. Prime the area

    A rubber primer is applied and given time to dry to the touch. Skipping primer is the most common reason patches peel.

  4. Patching

    Peel-and-stick EPDM cover tape or a cured patch is cut with rounded corners, pressed down and rolled firmly with a seam roller. Uncured flashing is used around pipes and corners because it stretches to fit.

  5. Fix the laps

    Failed laps are reopened, cleaned and resealed with modern seam tape. Lap sealant protects the edges.

  6. Wall flashing

    Bridged corners are cut free and new flashing is installed to relieve stress. New termination bar and counter flashing keep the top edge sealed.

What is included

Repairs a rubber roofer can handle

Perimeter repair

Shrunk edges get new flashing with termination bar where needed.

Seam repair

Open laps are resealed with seam tape with lap sealant at the edges.

Pipe boots

Pipes and vents get new rubber flashing sealed at the base.

Puncture repair

Holes and tears are patched with EPDM cover tape rolled for a full bond.

Coating

Compatible coatings can extend the life of weathered EPDM after proper priming.

Related service

EPDM Roof Repair Parsippany, NJ

Repairing EPDM is simple in concept but unforgiving of shortcuts. The rubber must be clean and dry, the primer must be scrubbed in and allowed to flash off and the patch must be rolled firmly so it bonds across its whole surface. Edges then get lap sealant for extra protection.

In Parsippany, rubber roof repairs are best done on dry days when the membrane is not too cold. Short-term fixes can protect the house until the weather cooperates. Temporary seals are not a substitute for a primed patch.

Related service

Rubber Roof Replacement Parsippany, NJ

There comes a point where patching an EPDM roof stops being worth it. If the roof has many patches and still leaks, or the insulation is wet in many places, replacement is the better choice. A moisture scan shows how much is still dry.

Some owners stay with EPDM, while others move to a white membrane. A tear-off is needed if the insulation is wet or there are already two layers. For a Parsippany home, an honest assessment saves money in the long run.

Local help

Rubber Roof Repair Near Me

In Parsippany, EPDM is one of the most common membranes on low slope sections of homes. From Parsippany to neighboring communities such as Lake Hiawatha, Mountain Lakes, Boonton and Whippany, storms and years of sun wear seams and flashing on rubber roofs, which keeps small leaks from becoming big ones.

Searching for rubber roof repair near me from Parsippany or Lake Hiawatha, Mountain Lakes, Boonton and Whippany? Call (862) 693-4349 to talk to a roofer who works in your part of town.

What the local climate does to a roof

Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Parsippany, NJ have the roof checked in the fall and again after the snow melts.

Why call

Why not wait

Less damage

A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.

Roofers who know Parsippany

Roofers in Parsippany know the roof types and weather wear common in local homes.

Clear next steps

Ask the roofer about the cause, the options and the estimate before work starts.

Rubber Roof Repair FAQ

How long does a rubber roof last?
Rubber roofs often last two to three decades. Thickness, installation and maintenance all affect its life. Repairs keep it on track.
Is roof cement safe for an EPDM roof?
Tar and asphalt roof cement should never go on EPDM. The petroleum in them breaks down rubber and blocks real patches from sticking. The right fix is a primed EPDM patch.
Can a rubber roof be coated?
A coating can extend the life of aging EPDM. Seams and leaks must be fixed, and the right primer is essential. Coatings do not fix wet insulation.
What causes EPDM to pull away from the edges?
EPDM shrinks slowly as it ages. The shrinking membrane tugs at the perimeter and bridges across corners. New flashing and termination bar fix it.
How is a rubber roof patched?
A proper EPDM patch is a cleaned, primed and rolled repair. The roofer scrubs the area with membrane cleaner, applies primer, lets it flash off, then presses down a patch with rounded corners and rolls it firmly. Lap sealant finishes the edges.

More questions? Call (862) 693-4349

Other services that may help

  • Rubber Roof Installation

    EPDM rubber roof installation with the right thickness, attachment method and flashing details, so the roof stays flexible and watertight for decades.

    Learn more
  • Flat Roof Repair

    Flat roof repairs matched to the membrane, whether EPDM, TPO, PVC, modified bitumen or built-up, after the real leak source is found, not guessed.

    Learn more
  • Roof Coating

    Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, after the seams and blisters are repaired.

    Learn more
  • Roof Leak Repair

    Finding where water gets through the roof and sealing it at the source, before wet decking and insulation turn into rot.

    Learn more

Looking for something else?

See all roofing services

Talk to a Parsippany roofer about rubber roof repair

Call (862) 693-4349 to talk to a roofer serving Parsippany, NJ.

Talk to a local roofer(862) 693-4349Call now

Free to call. No forms to fill out.

Call (862) 693-4349