High-heat underlayment
The deck is covered in underlayment made for metal as a second layer of protection.
Metal Roofing
Metal Roof Installation Parsippany, NJ
A roofer in Parsippany can install a new metal roof in standing seam, exposed fastener panels, metal shingles or stone coated steel, so the roof is set up for decades of service. One call to (862) 693-4349 reaches a nearby roofer who installs metal roofs.
The first choice in any metal roof installation is the panel system. Exposed fastener panels, such as corrugated and ribbed panels, are screwed through the face and go on quickly, but every screw has a washer that will need attention someday. With standing seam, hidden clips hold the panels and let them move, which is why it is the premium residential choice.
Metal type and finish matter as much as the profile. Most residential panels are coated steel, with aluminum preferred near the coast and copper or zinc used for accents and high-end work. A fluoropolymer (PVDF) paint finish holds color longer than a silicone modified polyester finish, and 24 or 26 gauge steel is typical for homes.
What goes under the metal is easy to overlook and important to get right. Panels normally go over solid sheathing and a heat-rated underlayment, with an ice barrier in the eaves and valleys. Outbuildings may use purlins, but a home usually gets full decking.
Metal Roof Installation is often paired with standing seam metal roof and metal roof replacement, depending on the cause.
Need metal roof installation in Parsippany? Call (862) 693-4349 to reach a nearby roofing contractor.
Call nowThe process
Installing a metal roof
A metal roof is measured, ordered and installed as a matched system.
Choose the system
The roofer helps you pick the panel type, metal, gauge, finish and color, then measures every slope precisely. Many panels are made to the exact length of each slope.
Get the base ready
The old roof is torn off or, where code allows, the metal goes over one layer of shingles with battens or underlayment between. Bad decking telegraphs right through thin metal.
High-heat underlayment
The deck is dried in with an underlayment rated for the heat that builds under metal. Some systems add a slip sheet under standing seam so panels move freely.
Edge flashing
The eaves and valleys get their flashing first so water flows from panel to trim. Getting the sequence right keeps water on top of the metal.
Run the panels
Standing seam panels are clipped and seamed, while exposed fastener panels are screwed through the flat or the rib as the profile requires. Metal filings are swept off right away so they do not rust stain the finish.
Finish the details
The ridge, walls, chimneys and pipes are flashed, and closures seal the gaps under the trim. On roofs that hold snow, snow guards keep it from sliding off in a sheet.
What is included
Parts of a metal roof system
System choice
A panel system matched to the roof pitch chosen to fit the house and budget.
Matched trim
Eave, rake, ridge, valley and wall trim in the same finish for a clean, finished look.
Penetration boots
Snow guards and flexible pipe boots are added where needed for safety and a dry roof.
Closures
Vented ridge closures let the attic breathe while keeping out rain and pests.
Related service
Metal Roofing Contractor Parsippany, NJ
A metal roofing contractor needs different tools and skills than a shingle crew, from panel benders and seamers to trim brakes for custom flashing. Good questions cover the panel systems they install, the underlayment they use and how they detail valleys and walls.
For Parsippany homeowners, the right metal roofing contractor will show how each system handles your roof shape. Looking at finished roofs is the best way to judge straight panels and clean trim.
Related service
Stone Coated Steel Roof Parsippany, NJ
Stone coated steel is formed steel topped with granules so it resembles tile, shake or dimensional shingles. The textured finish hides minor dents and quiets rain, and the panels are much lighter than clay or concrete tile.
Stone coated steel is usually installed over battens, which create an air space under the panels. On a Parsippany house that wants the look of tile or shake, stone coated steel avoids the extra structural load.
Related service
Metal Shingle Roof Parsippany, NJ
Instead of long panels, a metal shingle roof uses small stamped pieces that lock together. The interlocking edges hide the fasteners, and the small size suits complex rooflines with many hips and valleys.
In Parsippany, metal shingles appeal to homeowners who want metal performance with a traditional look. Installation details like starter, valleys and ridge are specific to each product line.
Local help
Metal Roof Installation Near Me
In Parsippany, homeowners choose metal for its long life, wind resistance and the way it sheds snow. From Parsippany out to neighboring towns such as Lake Hiawatha, Mountain Lakes, Boonton and Whippany, shingle roofs are being replaced with standing seam on many houses, and ribbed panels remain common on outbuildings, and a roofer who installs metal regularly will know which system fits each kind of building.
For metal roof installation in Parsippany, NJ or nearby towns like Lake Hiawatha, Mountain Lakes, Boonton and Whippany, call (862) 693-4349 to reach a roofer who covers your street.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Parsippany, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why not wait
Less damage
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Local roofers see the same roofs and storm damage across Parsippany and nearby towns.
Straight answers
Ask your questions before you agree to anything.
Common questions about metal roof installation
What is the lifespan of a metal roof?
A well installed steel roof commonly lasts forty years or more. Standing seam with a quality PVDF finish tends to last longest, while exposed fastener roofs need new screws along the way. Salt air, scratches and poor installation shorten that life.
How noisy is a metal roof?
On a house with decking and attic insulation, a metal roof is usually only slightly louder than shingles. Panels fastened to purlins with nothing under them make the most noise. Stone coated steel and metal shingles are among the quietest options.
What gauge of metal roofing should I use?
Metal thickness is listed as gauge, with smaller numbers being thicker. Thicker metal resists dents and oil canning better. Hail-prone areas benefit from thicker panels.
Should I choose standing seam or exposed fastener metal roofing?
It comes down to whether the screws are visible. Exposed fastener roofs show their screws and need screw maintenance, and standing seam hides its clips and lets the metal move. Standing seam is the usual pick for homes, exposed fastener for outbuildings.
Does a metal roof attract lightning?
Metal roofs do not attract lightning. Strikes depend on height, terrain and nearby objects, and a metal roof is no more likely to be hit than any other roof. If a strike happens, metal will not catch fire like some roofing can.
More questions? Call (862) 693-4349
Other services that may help
Standing Seam Metal Roof
Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, for homes, additions and low slope roofs.
Learn moreMetal Roof Replacement
Replacing a rusted or worn-out metal roof, or swapping an old shingle roof for new metal, so the new roof starts on a sound base.
Learn moreRoof Installation
Putting on a new roof the way the material maker intends, with ventilation and flashing planned in from the start.
Learn moreCommercial Metal Roofing
Installing, replacing and repairing metal roofs on warehouses, shops, offices and other commercial buildings, built to handle thermal movement and wind uplift.
Learn more
Looking for something else?
See all roofing servicesNeed metal roof installation in Parsippany, NJ?
Call (862) 693-4349 for a local roofer in Parsippany and nearby towns.